Products

Standard sanders leave marks. Waves. Bounce marks. Sand lines. These show up after you paint or laminate. Our Professional Sanding Machine fixes this problem. The sanding roller is tilted at 5 to...

Regular sanders leave fine scratches. You see them after laminating. Our Large Sanding Machine uses a different method. It has an air bag and a graphite pad. The air bag gives soft pressure. The...

That takes space and labor. Our Board Sander Machine puts both in one machine. The first head does thickness sanding. It takes off material and sets the board to the right thickness.

Single head sanders take one pass. You need a second machine or a second pass. The Double Head Sanding Machine has two tilted heads. Both are set at 5 to 8 degrees.

Most shops use three separate machines. One for heavy sanding. One for fine sanding. One for polishing. That takes space, workers, and time. Our Three Head Sander puts all three in one machine....

The biggest slowdown in sanding is not the sander. It is moving boards. Workers load. Workers flip. Workers stack. This takes time and can damage boards.

Cutting boards to size used to be slow. Workers would cut one side. Then the next. Then the next. This took time and gave uneven results. Our Lumber Edger cuts all four sides at the same time. The...

Standard edgers work for 4x8 foot boards. But many shops now make 4x10 foot boards. These are longer. Standard machines cannot take them. Our Sawmill Edger is made for this size.

Not every shop needs full automation. Some shops make many different sizes. Some have small budgets. Our Board Edger for Sawmill is for these shops. You put the board on the feed table by hand....

Scratches happen when workers handle boards. Fingers leave marks. Edges get bumped. Our Board Edger Machine stops this. Suction cups pick up each board. They put it on the feed belt. The board...

Rough boards are hard to handle. Edges are uneven. Surfaces are rough. Workers cannot get a good grip. Our Sawmill Board Edger is made for this job. It uses suction cups to pick up rough boards....

Moving stacks of boards is hard work. Workers use forklifts. They lift, move, and lower. This takes time. Our Roller Conveyor Lift Table makes it easy. It is a hydraulic lift with powered rollers...